Documentation
Speed Test
Speed Test (2nd PC)
Run a speed test to verify your DMA card is performing correctly before proceeding to firmware setup.
📝 Steps
- Ensure the cable is plugged into the DATA Port.
- Download the DMA Speed Test v1.5 ↗ or Speed Test Lone-DMA ↗.
- Extract & Run the tool on your 2nd PC's Desktop.
- Select Full Test and wait for the results.
📊 Speed Test Ratings
Low
< 4000
Warning
4000+
Good
5200+
Amazing
6500+
Elite
7500+
Getting a bad speed?
Try a better USB cable (USB 3.2 Gen 2x2) or a different USB 3.0 port or PCIe slot.
For higher speeds you will require a USB 3.2 Gen 2 port on your 2nd PC.
📈 Throughput Test Ratings
Low
< 125
Warning
125+
Good
150+
Amazing
200+
Elite
220+
❗ Important Note
If your results are below Good or you encounter errors, refer to the DMA Troubleshooting section before contacting support.
✅ Next Steps
Once you've confirmed your DMA card is functioning correctly, the next step is to flash your firmware.
If you purchased firmware from us (recommended):
We will need your DNA ID to build it. Find it here: DNA ID Guide ↗
If you already have firmware ready to flash:
Was this helpful?
Next
Troubleshooting