DeceptionDMA - BAAN Fuser Setup

⚠️ Before You Begin

The cables included with your Fuser are basic and may cause flickering, low refresh rates, or other signal issues. We strongly recommend purchasing certified HDMI 2.1 or DisplayPort 1.4 cables for the best experience.

Disconnect all displays except your main monitor.
Make sure the Fuser is powered off before connecting any cables.
Use only certified HDMI 2.1 or DisplayPort 1.4 cables for best performance and signal stability.

🔌 Fuser Layout

On the back of the Fuser you'll find three labelled ports:

Output — HDMI or DisplayPort
Input 1 — HDMI
Input 2 — HDMI

🔗 Connection Order (Fuser Off)

1️⃣ Output → Monitor

Connect DisplayPort 1.4 or HDMI 2.1 from the Fuser's Output port to your main monitor.

2️⃣ Input 1 → Game PC

Connect HDMI 2.1 or DP 1.4 from your Game PC's GPU to Input 1 on the Fuser.

3️⃣ Input 2 → Radar PC

Connect HDMI 2.1 or DP 1.4 from your Radar PC's GPU to Input 2 on the Fuser.

The Game PC's GPU must not be directly connected to any monitor. If a direct HDMI or DisplayPort cable is plugged from your GPU to the monitor, unplug it before setup.

Once all connections are made, power on the Fuser first, then both PCs.

Using lower-grade cables (HDMI 2.0 / DP 1.2) can result in no signal or screen flickering.

🖥️ Configure Display Settings

On Both PCs (before connecting to Fuser):

Connect each PC directly to a monitor temporarily.
Right-click the desktop → Display Settings.
Under Multiple displays, select Extend these displays.

On the Radar PC (2nd PC) only:

Go to Start → Settings → Personalization → Background
Set background to Solid colour → Black.

🔄 Reconnect Cables to the Fuser

Ensure all three cables are connected to the Fuser as per the connection layout above.
Confirm the monitor is no longer directly connected to the Game PC's GPU.

🎛️ Button Functions

K1 Display only the Radar PC's screen.

K2 Display only the Game PC's screen.

K3 Activate the overlay — continuous presses toggle and adjust overlay intensity.

K4 Switch the monitor's encoding format — useful for older monitor formats.

If the fusion light is on but no overlay appears, ensure the Radar PC's background is set to pure black.

🔧 Troubleshooting

Desktop apps are merged / two search bars visible

Press K3 (Main Screen Mode) when no overlay is active.

Second monitor shows "No Signal"

Ensure the 2nd monitor is turned on and connected to its respective PC — not to the Fuser.

Refresh rate limited to 60Hz or 90Hz

Not all cables are HDMI 2.1 or DisplayPort 1.4. Replace with certified cables.

Pink / Purple hue or no output on screen

If you see a coloured hue on one of your displays after setup, ensure both displays are set to 8-bit depth and RGB colour format. These settings are found in your GPU control panel.

NVIDIA Control Panel

AMD Control Panel